HI Jonny, sorry for the late reply I have just noticed this was not answered. I am not sure if additives will help against abrasion resistance? as...
HI, Unfortunately release film is not used for this purpose so we cannot recommend the best way to apply this as this is outside of the conventional...
HI Jonny, the silicone release does help in prolonging the life of the silicone mould however polyester resin is quite aggressive due to the level...
HI , Unfortunately we are not experience with the plastic injection. If it helps you can use polyurethane and polyester resins with this product but...
HI Chris, Epoxy is the best type of resin to use for under the waterline, it will give you the strongest repair. however you are right Gelcoat...
HI You can use aqua dynamic masking or fine line tape http://www.ecfibreglasssupplies.co.uk/c-18-tapes.aspx remove the tape from the mould whilst the...
HI Sean, I have just had the following reply from our friends at West System hope this helps :- For this you would be best Laminating a backing...
HI Sean, for this I would suggest getting someone to take a closer look on site preferable a marine surveyor to advise best course of action. I...
HI Ren, It would be best if you can form the fall before layering the fiberglass, it is quite difficult to lay the fiberglass in such a way that it...
HI Graham, Unfortunately I am not familiar with the adhesives used for standard car window installation but any supplier of these should hopefully be...
Hi Colin, unfortunately this is not something we have came across before. I know that Styrene can attack household gloss paints and acrylics such as...
HI , Best way to get around this is to apply strip layer to the problem edge horizontally, leave to cure then turn mould over and do the rest....
HI Graham, Please call us on 0191 497 5134 to discuss in more depth. Kind rgds Martin
Hi Dan , to remove the primer you have already applied you will need to sand it back, there is no liquid stripper designed for removing it....
HI David, it is difficult to how many layers this would take, it would be a case of just adding until you have a desired finish, try using a woven...
Separate names with a comma.